The figure shows the schematic for the square-wave-to-sine-wave converter. A crystal and a 10-MO resistor are connected across pins 5 and 6 of the RDD104. A 100-pF capacitor (C5) is tied to pin 5.

2. The 1-MHz sine and –cosine outputs of the generator (channels 3 and 4) result from the 100-MHz square-wave input (channel 1).

Med Dyer, Jabra Corp, San Diego, CAGenerating a square wave at a particular frequency is fairly simple. Many techniques for doing so exist, using counters, flip-flops, and–everyone's favorite–the ...

Sine wave output from the low-pass filter connected with D3. Wiring diagram Arduino sketch Now is the right time to make some key design conclusions regarding the power inverter stage. Yes, you can ...

n-jfet and p-jfet versions below are now modelled here Analog Devices published a very similar circuit (right) with a very nice description. Sinewave generation is something I had to do years ago, at ...

While sinusoid signal sources are used whenever low phase noise is required, conversion to a square wave-form is necessary when interfacing with digital circuits. Although have been analyzed a few ...