As the demands of the ignition system increase the wires are asked to shoulder a more burdening load and failure can have catastrophic consequences. 0:00 / 0:00 See All 11 Photos ...

High energy ignition (HEI) was introduced by General Motors in 1974 and became the standard for GM engines until the mid-1980s. An HEI system has three main components: an ignition module, a ...

PHINIA Inc., a leader in premium fuel systems, electrical systems, and aftermarket solutions, has completed the acquisition of SEM.

Most OE ignition systems will incorporate a power source (battery), ECU (brain), coil, distributor cap, rotor, plug wires and spark plugs. The eventual byproduct of all these components is an ...

Spotting and diagnosing an elusive ignition system fault can challenge even the best of technicians; but there are ways to both spot a sneaky misfire and cut down on diagnostic time, and you don't ...

The ignition system provides a properly timed spark to burn the air/fuel mixture for the power stroke of the four-stroke cycle. An eight-cylinder engine at 6000 rpm needs 400 sparks a second!

Classic Delco distributors seem to cover the gamut of types, ranging from single-point to dual-point in aluminum and cast iron. We're about to tackle a cast-iron, tach-drive distributor. This ...

Oshkosh, WI – July 22, 2019 – Lycoming Engines, an operating division of Avco Corporation, introduced the Lycoming Electronic Ignition System (EIS) today during its press conference at EAA ...