This is a very simple but useful project, strobe navigation lights for rc airplanes, or you can adjust the flashing time and ...

Construct a simple RC low pass filter circuit, using your capacitor. 2. With input level constant, sweep the input over a wide range of frequency (sine wave), and plot the output level response. 3.

With this simple circuit, you will have a strobe navigation light system with LEDs in your rc model aircraft or you can use ...

“The LED may also flash when the E and C leads are switched, but the flash rate will be faster,” Gerbig explained. “This reflects the fact that some types of transistor will operate with their emitter ...

A Simple Over-Voltage Protection Circuit for LED Drivers This boost circuit implements current mode control and senses the LED current via resistor R14. The output voltage is boosted to just over 30V ...

A single-op-amp-based“anticipator-like” circuit generateda more faithful picture of theactual input excitation, and improvedon the circuit described in a previousDesign Idea (Reference 1). The ...

It is not possible to make an inverter with a simple RC circuit. However, one of the exercises proposed in a previous tutorial suggested interesting considerations on the output signal of a series RC ...

Abstract: GAM, TPN and AWE methods have been accepted by many researchers as methods of modeling on chip interconnects as RC, and RLC circuits. In this paper a platform to generate the T and Π ...

Construct a simple RC high pass filter circuit, using your capacitor. With input level constant, sweep the input over a wide range of frequency (sine wave), and plot the output level response. Repeat ...