First, with the two router topology (repeated below), if you are already a CCNA, you can probably predict what CCNA-level tasks can and can’t be done with this topology.

2) Confirm that each router can ping the other router’s serial IP addresses. 3) Configure RIP such that R1 has exactly one route for subnet 172.16.1.0/25, which uses R1’s S0/0/0 (or equivalent ...

A full mesh topology relies on every site's WAN router having a connection to every other site on the wide area network. Full mesh topologies provide a high degree of dependability and fault ...

Your router would route between them, unless you get an L3 switch (more money) in which case your switch can do it. edit: the switch you're planning to buy is fast ethernet only. If you're ...

TOS Discovery is built into the Tufin Orchestration Suite, and automates discovery of all Cisco routers/switches on a user’s network, keeping topology always accurate and up-to-date.

TL;DR / Original Post: I have two ISPs for my home network. They are connected to two separate routers. If I run radvd and dhcpd on both routers at the same time, I get no IPv6 connectivity.

The wireless networking research community has long been using simulation as a method to conduct studies on new protocols, algorithms, and features. An important, and often neglected, component of ...

Then, the topology router automatically routes the bus interconnects, following the pathways defined by the engineer. The resulting routing has the structure and quality usually provided only by ...

For a mesh network to be effective, at least one of the routers needs to sit out in the open in your home. And that’s just not going to happen if it looks like a giant plasticine cockroach.