News

Assuming an op amp is required for one reason or another, the task of its selection is a critical one and not at all straightforward. Figure 3-21 lists a few of the constraints and variables. The most ...
Figure 6 shows the distortion vs. amplitude for the input stage. This will appear (times the noise gain) at the output of the application circuit. You may get more output distortion than this, but not ...
Some op amps are specifically made to work with a single-ended supply so their negative supply can connect to ground. Of course, that presupposes that you don’t need a negative voltage output.
1. Here’s an op amp connected as an inverter (a), and its input-output transfer curve (b). One way to look at the operation of a comparator is to examine the basic op-amp configuration shown in ...
For small voltage systems (3.3V), a quad low-voltage rail-to-rail output operational amplifier (op amp) such as the LMV324 can be used in a single supply system, but ground should be replaced by Vcc/2 ...
Reliable Wire-to-Board Connections with Phoenix Contact CONNEXIS The simplest op amp comprises a few basic components: the input resistance, a gain element, and output resistance (Fig. 1a).
A note: For convenience, that is also where the op-amp diagram (top) came from – the one in the diagram is a 8MHz rail-to-rail op-amp, surely over-kill for such an application, when cheap slow 30V ...
When it was first introduced in 1968, Fairchild’s 741 op-amp made quite a splash. And with good reason; it packed a bunch of components into a compact package, and the applications for it wer… ...
Texas Instruments' 36V rail to rail input/output op amp combines low offset and drift with fast settling to improve precision a/d converter performance. The OPA192 achieves stable offset voltage drift ...
I was pondering possible interfaces between a microcontroller and a 12 or 24V 5015 blower fan. The challenge is that the MCU can only drive 3.3 or 5V, while the blower needs needs a voltage as low as ...